RF-2W803-SS with evo one not programming

Question

I am using the included ft-d100 adapter that came with Compustar RF-2W803-SS. I grounded and connected the 12v adapter. I went through the steps in the programming guide. Turn ignition to on position, press and hold valet button until horn chirps, press valet button 1x, press brake 1x, press lock button on remote, press brake 1x, turn off ignition.

I did not modify the 4-pin connector at all. The 4-pin connector has the white and blue wires crossed like suggested. 

Is there another way to program the rf kit?

Answer 1

I had this issue and it was related to valet mode.  Try exiting valet mode to see if it can program then.  To exit valet, turn key to run and within a few seconds press the valley button 3 times slowly.