Hello,
I really need some assistance on the following.
I have been trying to get this REVO 1.1 to program to the EVO-ONE for the last two days. I have followed the instructions very closely. The only issue I potentially see is, and the instructions are unclear on this, do I need to use the power adapter?
My EVO-ONE was installed without a T-Harness, the guide states. "The power connections are only needed for the EVO-ALL and ADS-ALCA integration modules. The EVO-ONE will not require these connections." then later, in the same paragraph the guide states "If you are NOT using a T-Harness, then you WILL need to connect the power and ground wires."
So, do I need the power adapter, or not?
I can't get the REVO 1.1 to program using the steps in the guide. I turn the ignition to ON, I see the yellow LED turn on, on the EVO-ONE module. From there, I hold the valet switch until I can see the red LED turns on and flashes rapidly, and then press the valet switch 5 times, and using the parking lights to confirm each press, followed by pressing the brake one time.
Afterwards, I hold the remote button (the only button) for up to 3 seconds as stated in the guide, but I never see the red LED flash to confirm programming, followed by pressing the brake pedal, and turning off the vehicle. I continued with the steps in case I missed the red LED flash.
This install is on a KIA Soul 2016 - standard key - using the latest firmware for both the module (76.39) and the remote start (1.29).
I made sure to select Fortin2 on the remote start settings in the software as well.
If anything, I will call support on Monday, but I can't believe that I can't seem to get an answer on this anywhere.
I have also tried downgrading the firmware to 1.16, but that didn't work either - I was not even able to get the module to go into programming mode after that.
EDIT:
Here is the answer for anyone that needs it!
The guide leaves out information about having to select which wires were set up on the vehicle - somewhat odd to leave the information off entirely...
I have attached a link of a screenshot to the software option, these options should have been included within one of the steps shown on the installation instruction documentation.
