Starts but wont wait for the grid heater to come ON

Question

FIXED AND WORKING almost, now with a diesel mode D1.3 selected and flashed and saved checked 3 times the truck will start but didnt wait for the grid heater to come on started right away!!!!

 

LOOKS like I have to downgrade firmware to 0.36 only need to know if this can be done without a master reset?

Answer 1

OK there is no 74.36 firmware so I went with the install sheet which tell you to use 74.29 min. So now I am at

Hardware 6

Firmware 74.[29]

 

And still no delay in engine start with diesel D1.3 ON and 30 min run time

Comments

OK tech support just gave me the bad news, the EVO ALL is a poor choice for the RAM diesel, you are stuck with a short delay 10 sec and thats about it. there is a BETA firmwre at the bottom on the page in flash link that will give you around 14 sec delay I may try but the key decrip only gives you 3 shots and you have to call and get it unlocked and my take 48 hours to do it. SO buy an EVO ONE and save you time and problems