little lost on install

Question

in the process of installing the evo fort1 with t harness on a 2010 ford edge limited, this is my ist time installin a t harness remote installed a few direct wires, bought the harness thinking it would make it easier for me, but seems not.

right now i have the entire T harness installed along with can hi and low 

im following guide# 32171 on page 5 shows all the wiring, im a little lost on which wires i actually have to hookup?

im assuming the headlights through the relay, and drivers door pin are all that's needed ? the rest is covered by the t harness 

i have programmed my evo all

service# 001a06 698678 turning on C1 & D1 and turning off A5, i also turned on low temp seat heaters 

thanks for the imput ..Tony

i# 32171 

Answer 1

There are three wires from the T-harness that need to be connected to the Evo-All. The lt-blue, lt-blue black, and yellow wire off of the T-harness need to connect to the same wires on the 20 pin connector. The Can High and Can Low connections are also required which are made directly to the vehicle.

Comments

awesome thank you for your reply, and the programming looks ok? using it as a astand alone remote strat using fartory fob 3 lock pulses

---

Your options look good, but it's showing a failed Dcryptor attempt.

 

Please verify that only 3 out of the 4 wires from the t-harness is being used, Yellow, LIght Blue and Light Blue/Black. The Yellow/Black from the t-harness should not be used at all.

 

Are you sure this is a 2010 and not a 2011? Can you please tell us the 10th character from the left of the vehicle's vin

 

Thank you,