Questions & Answers

Flashing Red LED After Programming

0 votes
After first stage of programming the EVO-ALL with my Mazda 3 '15, programming with the computer, then following steps 1-12 again (Guide 62681), the EVO flashes RED with no other lights. I tried following all steps again a few times, with the same result. The security light on the car rapidly flashes for a few seconds as well. What should I try next?
asked Dec 23, 2019 in Mazda by Elliot Thomas (230 points)
edited Dec 23, 2019 by Elliot Thomas

1 Answer

+2 votes
 
Best answer

Flashing red means unit was already paired with the car. 

 

Try this...

 

In the last part of programming, if the blue led turns off and then it alternates through all the colors, programming failed, do not continue. 

If the blue light turns off, then starts to flash blue, programming = successful. Test the starter. Note, key cannot be close to the car. 

answered Dec 23, 2019 by Robert T (297,620 points)
selected Jan 19, 2020 by Elliot Thomas
Thank you so much Robb! I'll try this out this weekend. I really appreciate your help!!
Thank you so much - that was it!
Glad it helped!
...