need help with evo-all wiring.

Question

Installing viper 5704 on 2009 F-150 with evo-all, my questions are regarding evo-all plug A pin A4 and plug D pin D3 and D1. per the istallation in w2w mode, Pin A4 should go to alarms (-) door trigger is this correct?  and D3 and D1 to F-150 door trigger wire, D1 to one side of the cut wire an D3 to the other side is this correct??

Answer 1

Pin A4 should go to alarms (-) door trigger is this correct?

Yes.

and D3 and D1 to F-150 door trigger wire, D1 to one side of the cut wire an D3 to the other side is this correct??

This one's a little tricky. It depends on which firmware you are running on the EVO-ALL. If you are using firmware 4.18 then yes, use D3 and D1 to go on either side of the door trigger wire. If you are using the Ford specific firmwares 71.XX, you will need to use the Green/White(A17) and Green/Red (A18). You would need to then connect them to the door trigger this:

• Green/White (A17)    -   Door side of door trigger
• Green/Red (A18)       -   Vehicle side of door trigger

---

Basically, if you're using the 71.XX Ford firmware, do the door lock trigger like the picture below